supatime
Getting To Know The Place
- 9/6/24
- 22
- 19
- 3
Here's mine. The date window and 3 o'clock marker are crooked. Obviously very zoomed in, far closer than any human being would look. Adding a picture for future Ingenieur connoisseurs.
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
V7 will release Ingenieur!
- Thread starter Reaps
- Start date
Here's mine. The date window and 3 o'clock marker are crooked. Obviously very zoomed in, far closer than any human being would look. Adding a picture for future Ingenieur connoisseurs.
Think mine looks pretty aligned
Lmao both of yours look perfect in my eyes. Mine is much worse than both. But like I said. When my watch is on the wrist, I don't notice the crooked 3 o clock marker. It's noticeable only in photos. Not in person.
I received mine in white today.
A beauty after all black divers.
Since it was too tight and individual links on my TD didn't work, I immediately ordered additional bracelets.
If anyone in Europe needs additional links, I can help.
A beauty after all black divers.
Since it was too tight and individual links on my TD didn't work, I immediately ordered additional bracelets.
If anyone in Europe needs additional links, I can help.
there is always bit of hope but I think no. case is easy to rep but tit bracelet with gen like spec is the problem imo
I opened mine just to grease the gasket. Do you know if the cover is the same as gen? (should be soft-iron..)
montanari
Known Member
- 5/4/24
- 112
- 177
- 43
Sent you a message a couple of days agoI received mine in white today.
A beauty after all black divers.
Since it was too tight and individual links on my TD didn't work, I immediately ordered additional bracelets.
If anyone in Europe needs additional links, I can help.
I really hope V7F also released a rep micro adjust clasp. With two links taken out, the bracelet is a little too tight. With one link taken out, the bracelet is a little too loose. I wish there was a half link I could take out but unfortunately nope. A micro adjust clasp would've been perfect and there's no way I'm spending $500+ for a gen clasp!
I agree. He'll probably need one at most. I'm at 17.1 and removed one link (removing two makes it a little too tight). Worst case scenario he might need just one link.
Did you take the cover off to see if the rotor and stuff are like gen?I opened mine just to grease the gasket. Do you know if the cover is the same as gen? (should be soft-iron..)
Nope, because i was greasing all my watches, so did not have the time... will do next time!
- 26/12/13
- 4,649
- 3,130
- 113
The stock bracelet will fit 19 cm, nothing more. I think you should take at least 2 links. Links are not the same size, so maybe take 2 big ones and a small one for better fit.
munichman
Active Member
You sure it´s not a Gen?
The differences between your´s and the previous picture are huge.
You figure maybe v7f sent out their gen sample by mistake when filling a rep order?
