-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
Another Moonswatch metal case project
- Thread starter dacodo
- Start date
$25 USD each for the Replica Casebacks.
Yeah the 13.7 is my favorite, also without the newer blueish Pagani AR coating.
I believe we might place a group purchase given the common interest
Depending on what the bulk discount is and how much solo shipping to everybody here is, that could work!
Very true, on a second thought it wouldn't be very convenient moneywise, not enough to spend time on a group buy
I think if we did a group buy we'd do full cases with bracelets. I could handle US side shipment and also include the 3d printed movement holders at no extra cost. Could also include a single PE50 stem for a small fee as well. Would pretty much be a build kit at that point!
Parnis just released this
It would be an ideal case for a FOIS build.
It’s still expensive as it’s a new launch but I will grab it at the first promotion
My prototype FOIS is not bad but the case could be better
It would be an ideal case for a FOIS build.
It’s still expensive as it’s a new launch but I will grab it at the first promotion
My prototype FOIS is not bad but the case could be better
Looks good. That red bezel and gold combo could be cool for some variants!Parnis just released this
It would be an ideal case for a FOIS build.
It’s still expensive as it’s a new launch but I will grab it at the first promotion
My prototype FOIS is not bad but the case could be better
Thread 'Blancpain X Swatch - Experiments and prototypes'
https://forum.replica-watch.info/threads/blancpain-x-swatch-experiments-and-prototypes.10997167/
There is a lot to like about the Pagani 1701 case:
But I would like to seek advice from you fine (and not-so-fine) gents who already have done the Pagani case mod-
What did you do about the crown? The standard AliX crown that works on the standard AliX cases does not fit to this tube.
But I would like to seek advice from you fine (and not-so-fine) gents who already have done the Pagani case mod-
What did you do about the crown? The standard AliX crown that works on the standard AliX cases does not fit to this tube.
Last edited:
Pop the tube off and put a crown with the right tubeThere is a lot to like about the Pagani 1701 case:
But I would like to seek advice from you fine (and not-so-fine) gents who already have done the Pagani case mod-
What did you do about the crown? The standard AliX crown that works on the standard AliX cases does not fit to this tube.
It should be 2.5mm in
I never keep the stock tube. It is slightly longer than the rep crown tube so the crown never sits flush if you don’t change the tube
Last edited:
*SIGH*
I have been avoiding even thinking about that since I started this terrible hobby. And having a hard time justifying the $40 on a crown tube press from Ali.
Generally how hard are they to push out? Maybe I can jig something up and ruin a perfectly good case.
If you are confident and accept losing the pagani tube, then just yank the tube out with pincer pliers
Another option is to use a 2.3 mm stake to push it out with a hammer
But you need balls
Another option is to use a 2.3 mm stake to push it out with a hammer
But you need balls
Last edited: