Besides QC issues such as this, replica bracelets are quite nice for their cost.
Guarantee the seller would be willing to work with you, but I do not guarantee that it will not take some negotiating and perhaps added cost.
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
Very upset with Noob Daytona 904s bracelet
- Thread starter efthimis
- Start date
Besides QC issues such as this, replica bracelets are quite nice for their cost.
Guarantee the seller would be willing to work with you, but I do not guarantee that it will not take some negotiating and perhaps added cost.
I would mind just to receive 2-3 links to replace these three but yet again if I had access to a descent watch-smith I would be hassle free now.. anyway this is a very beautiful watch and no need for modding unless you are a perfectionist (or anal to detail lolol!!!)
Sent from my iPhone using Tapatalk Pro
Beautiful watch, very interested in this model. Would it be within reason to ask a TD to loosen the screws for you during the QC process?
Subzed
Active Member
- 24/4/18
- 208
- 111
- 43
I had good luck with a strong hairdryer but let it sit an inch away for about 15 minutes on high. If I had a heat gun I would have used that. It would’ve even more efficient and less time consuming. I would have been leary of using a blow torch on it in my basement work bench.
I have to add what I didn’t mention before; after using the penetrating oil and heat, I stopped halfway and repeated the process because it started to get difficult again. After that it finally came out.
I just sized the bracelet on my new VSF Seamster 300m gray dial, using overnight penetrating oil and hot hair dryer, it was a headache but in the end I accomplished it. Damn link screws, one of the true letdowns in replicas.
