- 27/12/16
- 6,353
- 1,568
- 113
https://trustytime.io/index.php?main_page=product_info&cPath=37_49&products_id=22253
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
XF Factory PAM005 finally out.
- Thread starter Repworld
- Start date
If the XF 111 is anything to go by, then this is going to be just fine.
Can't go too far wrong with either the Noob or XF versions.
Can't go too far wrong with either the Noob or XF versions.
- 27/12/16
- 6,353
- 1,568
- 113
I like pam 005 and don’t like pam with open case back .
Sent from my iPhone using Tapatalk
will be good to see some macro's of the sausage lume structure to see if they have got it right or not. I have a gen dial for comparison. In the past it was the H-Fac dials that was the best rep dials for this.
- 27/12/16
- 6,353
- 1,568
- 113
I hope there’s side by side same pam 111 and gen replication, if not I will waiting imo noob.
Sent from my iPhone using Tapatalk
Although Noob was extremely good in the past, the sausage lume application was wrong, slightly raised and not flat, worse than H-Fac.
Sent from my iPhone using Tapatalk
I completely agree with superspark69 . If their dial is similar to the past XF 005 and 005, then this is a very good solution and I would prefer the XF over the noob. I hope they don't make it worse than they did.
- 27/12/16
- 6,353
- 1,568
- 113
I could be wrong, but should 005 have a hole for removing the bezel, or is it a shadow?
It seemed that it should be threaded, and this type of fastening was practiced only by HF
It seemed that it should be threaded, and this type of fastening was practiced only by HF
Yes, of course, at least the logo on the dial, solid caseback, and the dial is not a sandwich, but a sausage.
I could be wrong, but should 005 have a hole for removing the bezel, or is it a shadow?
It seemed that it should be threaded, and this type of fastening was practiced only by HF
all 44mm luminor bezels should have a pry hole, none are screwed
:facepalm: Better late than never ... Thank you ... Apparently, I started to notice them on HF, because they are more obvious ... Anyway, thanks, and I apologize for the silly question.