I was looking at your work done on Reddit and screen shot a few.
Idk you and Oascom personally so I can offer a unbiased opinion. Your plating finishing is cloudy/hazy and very cold in appearance. It's very inconsistent. I don't think you are using a clean workspace/practice. You could have 8g/L solution but if your preparation is sloppy and dirty it's absolutely pointless to be plating anything. It doesn't look like you regularly check the pH levels either or use the right volts. There is burn spots.
I saw you commented to someone about extreme heavy plate or something like that but its not possible to offer when your using low gold content.
If you look at oascom plating you will see it is not cloudy, and it's in fact consistent. He also has a softer warm look in his finish.
Unless you have other pics I would choose oascom.
I was looking at your work done on Reddit and screen shot a few.
Idk you and Oascom personally so I can offer a unbiased opinion. Your plating finishing is cloudy/hazy and very cold in appearance. It's very inconsistent. I don't think you are using a clean workspace/practice. You could have 8g/L solution but if your preparation is sloppy and dirty it's absolutely pointless to be plating anything. It doesn't look like you regularly check the pH levels either or use the right volts. There is burn spots.
I saw you commented to someone about extreme heavy plate or something like that but its not possible to offer when your using low gold content.
If you look at oascom plating you will see it is not cloudy, and it's in fact consistent. He also has a softer warm look in his finish.
Unless you have other pics I would choose oascom.
I tried persuading you all into stopping this, but now even Pat is going at him.... please continue.
Marmalade jars... dirty ass power adapter.... I am tearing up....
