so, with the 25-21 it also could be used for a 1016 project
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
Aftermarket/Rep 16200 Datejust Cases from S.Korea
- Thread starter Stone P
- Start date
side profile looks pretty dope but aren't the holes too wide?
Bottom picture his case.
- 5/4/22
- 129
- 167
- 43
I will order one of those cases and write a review about a new DateJust build with it
Gen Dial is already in transit
Gen Dial is already in transit
Btw he claimed it looks bigger on the picture.
The holes are 1.0
Hi guys, this is my offer on ebay - I wasn't allowed to post here and answer your questions until I got seller status to be able to sell my parts on RWI. It's been fun watching the discussion here and responding to your posts on ebay 
Here are some photos
Raffles vs my version:
How it looks assembled:
Raffles vs my version:
How it looks assembled:
- 2/10/09
- 1,093
- 302
- 83
Thank you
Hoping there be some engraving in the future.
Nevertheless good job!
I work on engraving. Will see. Raffles. 455b links has been bent a little bit.
Yes, but you will need 16200 bezel then - this is higher.
freebalkany
Active Member
- 24/8/21
- 298
- 310
- 63
This is so cool!Here are some photos
Raffles vs my version:
How it looks assembled:
I have a 16030 build in the pipe, I already have the dial, datewheel, bezel and hands. I might buy your case on eBay soon!
new aftermarket Datejust 16000 case
Hey guys, A while ago, I got into 3D modeling, just as a new creative outlet. Eventually, I bought a 3D scanner and for fun, scanned my gen DJ36. Not long after, I ended up selling the watch since I was mainly wearing larger pieces at the time. But the scan stayed with me. Back then, I owned...
forum.replica-watch.info
You won't get such a case made in Europe for 170€ (tax exluded)
I wrote a ton of requests - the cheapest offer was 380€ + VAT for minimum 300 sets...You won't get such a case made in Europe for 170€ (tax exluded)
Still not sure if posting here or on dedicated thread would be correct…
So here we go:
Will a 16030 ETB fit?
So here we go:
Will a 16030 ETB fit?
Yes, the measurements are same as gen, so you can install 25-135 or 25-118 plexi as it was on the gen and then of course ETB or other bezel.