- 18/3/13
- 14,093
- 2,220
- 113
I had noticed a thing here as in my previous V6S compared to another V6S I had here at home. Inside the bracelet hole to pass the spring bars there is a burr processing that is not removed from machined.
In sub V6S with recessed sel that i has this burr was not present but in the sub with sel flush this burr was present.
In this case it was hard to remove the springbars from the bracelet, while the other sub with sel to a recess the sprigbars was off smooth like butter.
After I had removed the burr inside the hole in the springbars it flowed perfectly and the sel were low now.
I had I noticed this burr processing is also present in this YM with sel flush bracelet, and that its springbar is hard to remove, as the old sub with sel flush.
So I will try to remove the burr, because the bracelet of YM with recessed Sel (like my old V6S with recessed Sel) hasn't this burr.
Ok let me know how it goes.