- 5/10/18
- 375
- 69
- 28
What's the best from yuki?In my experience it takes longer to find the right one M2M than the Raffles/Yuki delivery.
I will buy one from him.
Help me get a good one
Inviato dal mio STF-L09 utilizzando Tapatalk
What's the best from yuki?In my experience it takes longer to find the right one M2M than the Raffles/Yuki delivery.
I'm no Explorer expert, so I can't help you with that.
To me the ones for the gen movement look better than the ETA versions.
Very cool tool. You could sell those.....now i have a new tool
Hey mate,
This looks very promising. In my opinion you reached a point where the rest of the watch (dial, crown, crystal, etc.) needs more work than the case itself. If you could reproduce this in quantities, you're golden. Brilliant work on the hole drilling jig.
I'd take a 2824 16030 case of yours.
Great to know Sir .
Tomorrow or in the next day i will start drilling 1mm holes for a my personal 16000 case . I will fit a 25-135 glass and a gen engine turned bezel .
For example i need same advice for the next 16000 case .
First of all : spring bar for a 16000 case (what are the correct one to use?
Second of all : crown for 1016 and 16000 case ( a good quality replica )
this is my latest crown buyed .the one in the picture https://www.ebay.it/itm/293334557443
Great to know Sir .
Tomorrow or in the next day i will start drilling 1mm holes for a my personal 16000 case . I will fit a 25-135 glass and a gen engine turned bezel .
For example i need same advice for the next 16000 case .
First of all : spring bar for a 16000 case (what are the correct one to use?
maikols as far as the springbars are are concerned, you need 20mm width, 1.78mm diameter double flanged. You can find them both in gen and rep in fairly low prices. I believe gen is around 3-4€ for a pack of 10.
You can count me on a 16000 series case too lol. I’ve been following this for a while now. Do you have a price for these yet?