- 27/3/08
- 838
- 56
- 28
even with shaved stock gasket or aftermarket 2.3mm gasket (tried both), i cant get the overall thickness lower than 12.66mm. any suggestions?
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
Quick Review of Clean Factory New Daytona 116500 Black Ceramic Insert vs. Gen
- Thread starter jtimewatch
- Start date
even with shaved stock gasket or aftermarket 2.3mm gasket (tried both), i cant get the overall thickness lower than 12.66mm. any suggestions?
- 27/3/08
- 838
- 56
- 28
i got the clean bezel on though, but it wasnt easy. despite using a press, the bezel wouldnt slide down horizontally, but in an angle. to prevent breaking, i put plastic washers under the bezel, replacing with thinner washers gradually in steps as i pressed down full in each step
Did you measure the gasket? Mine is 2.35mm for example...
also closing hard the caseback with the correct tool coild give you some 0,0X mm of slimming
Last edited:
Bobi01
Respected Member
- 2/2/19
- 3,913
- 3,446
- 113
Hi i have question? Does someone know what specs does Clean factory bezel has? Bright high...? Thank you
Real platina, not too white and not too dark,something like silver
Bobi01
Respected Member
- 2/2/19
- 3,913
- 3,446
- 113
I dont know if its this correct? I want to order custom bezel
You dont need custom bezel if you have clean,clean is best so far
Bobi01
Respected Member
- 2/2/19
- 3,913
- 3,446
- 113
For my wife something special a little bit bling bling robi
Ahh i remember now haha ,you need dimension? Experts know here i hope
- 16/6/15
- 591
- 205
- 43
Can someone help me out with my QC of my CF bezel? Ordered it from Ryan at InTime, who, originally, didn't have on his site, but said that he could order it for me. My specific concern with the QC images of the CF bezel is that the bezel numbers and text look rather grey and dull vs. the bright white-platinum colour I have come to expect. Are my eyes tricking me or should I red light this because of the duller colour? Any help would be great, thanks!
- 9/12/17
- 1,092
- 390
- 83
No wrong with the engraving.
Please request for a shot to show the back of the insert.
I know Ryan is a stand up guy, just to be sure...
No wrong with the engraving.
Please request for a shot to show the back of the insert.
I know Ryan is a stand up guy, just to be sure...
They sent me a picture of the back engraving. It says "clean" like the picture that you sent me. Should be fine! Thanks for helping out.
Put a little bit of grease on the inner of the bezel before press it on the gasket.
You will insert it smooth
Tobel
Respected Member
- 6/7/17
- 5,456
- 3,673
- 113
CF is known for their ceramic inserts. Not saying they couldn't do a steel one but that's a very different type of manufacturing process so I don't suspect so + less demand than the newer 116500
Oh I wasn't aware of that, thank you for finding out, I think it's a shame there's so much room for improvement on this 116520 and a fairly constant demand