Noob Pam 111 V3 After refinish....

[koko105]

This is an amazing jobunk:unk:

 

[shelby1501]

I know it's old thread but can OP or anyone else with experience tell me which grid to use to refinish crown guard?

 

[kilowattore]

I use 400 then 600 then a light pass with 800. Check carefully after each step and use a piece of wood as a ruler

 

[shelby1501]

I use 400 then 600 then a light pass with 800. Check carefully after each step and use a piece of wood as a ruler

Thanks a lot A, I appreciate it! Rep points on the way!

Edit: have to spread some reps before I'm able to leave to you again.

 

[Maahinen]

Well done, nice watch

 

[Knifemaker]

I polished hardened SS and other metals for a living for over 40+ years. I would like to congratulate you for a Job Well Done!
You achieved a high level of finish, "without" rounding the corners, or loosing the profile. NOT an easy thing to do. NICE!!!

Knife