Not for the moderate cost build. The most accurate is Phong but if you are going to that level you will want a gen spec build in his case set.Does anyone sell an accurate caseback that will fit these new guys?
I have a rivet coming from Tony. He could only find the one made for the big crown case so it's 19mm. Hopefully the 20mm end links from the jk will fit. I'm not sure the end link opening is the same size but a Drexel will take care of any size issues.You can also buy the rivet from Mary seperately
Sent from my SM-G900P using Tapatalk
Thanks a ton. I'm just hoping for compatability and not perfection luckily!@Soxxgo2
Comparing the last bracelet links are as follows:
Mary's rivet last link measures 8.6mm
Rep 7836 folded last link measures 8.69
Gen 7835 folded last link measures 7.06
Gen 93150 last link measures 8.69mm
End link openings are as follows:
Gen 501b measures 9mm (20mm out)
Gen 593 measures 9mm (20mm out)
Gen 357 measures 7.5mm (19mm out)
My experience is that a 19mm bracelet setup attached to a 20mm end link and lug is very sloppy. Pretty obvious as well.
That's correct for the tudor snowflake.New member digging up an old thread to ask a stupid question, sorry.
Anyways, all the TD listings for these Tudor Sub reps state bi-directional bezels. Can anyone confirm if this is correct? Is that 1:1?