Any link of the watchbus forum topic, I could not find it?
The crown looks aligned to the pushers
Is that right or wrong vs. the gen?
I was hopeful atleast.. but they shouldn't be aligned. The gen's crown position is higher than the pushers because of the movement.
It's pretty much an easy tell if you know this bit.
Sure, a gen dial will always be superior to a rep dial if you're willing to invest the effort and the money. I hope the rep dial will be impressive enough though![]()
I was hopeful atleast.. but they shouldn't be aligned. The gen's crown position is higher than the pushers because of the movement.
It's pretty much an easy tell if you know this bit.
I am looking forward to this report - thanks!
I've been holding off on a 3714 for what seems like ages, in eager anticipation of this development.
Thanks for the updates, everyone!
The zf 5001 dial is 99% 1:1... If their 3714 has the same accuracy I wouldn't bother...
It's very good but not 99%, put them side by side and you will see the differences.
The quality and finesse of the a gen portuguese dial (5001 or 3714) is what makes it special and the rep comes very close but does not match it to 99%.
Ok 99% might be a bit too high. But the quality and gen-ness is definitely above standard rep...