-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
XF New AP Royal Oak 15202 Releasing Soon!
- Thread starter jtimewatch
- Start date
Tigerdragon
Mythical Poster
- 19/10/13
- 7,292
- 1,687
- 113
gilrob
Legendary Member
I’m not worried lol. If it goes tits up it’s easy/cheap to repair. I was just pointing out the fact that the ‘custom A2121 movement’ claim from the factory is bullshit, it’s a stock miyota 9015 with the the quickest date gear removed, a different rotor and a capped seconds pinion. Even still, it’s a great attempt by XF
Did these modifications help in making the movement thinner.
The capped pinion helps as the crystal can be seated closer to the dial without a seconds hand. Not sure if the rotor is thinner than a stock one to be honest, looks about the same.
I’m not worried lol. If it goes tits up it’s easy/cheap to repair. I was just pointing out the fact that the ‘custom A2121 movement’ claim from the factory is bullshit, it’s a stock miyota 9015 with the the quickest date gear removed, a different rotor and a capped seconds pinion. Even still, it’s a great attempt by XF
Amazing information! I had no clue it was a stock miyota with one gear removed. That'd be very pertinent information for my watch maker when I bring it in for servicing.
So the miyota 9015 is a movement used in ultra thin applications I'm guessing?
Yes that’s all it is. XF have finished the movement with Geneva strips and perlage also, the finishing isn’t a stock miyota finish.
Yes the 9015 is 3.9mm thick.
Last edited:
I’m sure your watchmaker would take a look and know what’s going on.
Sent from my iPhone using Tapatalk
Hello community! Sorry for noob question but how to manually wind this watch? In crown position 0? As I understand it has 2 positions in total - regular and for time adjustment and date is also adjusted by hour hand?
I’ve never owned a watch that couldn’t manually wind in the 0 position of the crown.
I’m assuming this watch is no different but again, I could be wrong.
VaderTime
Active Member
- 9/10/17
- 450
- 167
- 43
Almost any watch with a mainspring can be manually wound in the first position, some require an unscrewing of the crown and others not. Depending on the actual movement, positions 2/3 serve different functions like date and time adjustments but position 1 is almost exclusively for winding the watch.
SuperLory
Well-Known Repist
- 22/10/15
- 8,464
- 5,060
- 113
Hi, would you please tell me what type of oil have you used to lube the rotor bearing?
closedose
Do not accept unsolicited offers
- 2/12/19
- 8
- 1
- 0
Looks like someone on Reddit posted their first IRL photo of the XF 15202 - https://www.reddit.com/r/RepTime/com...f_has_arrived/
Zoomed in - looks like the AP logo is a bit wonky (not straightened) but everything else looks on-point and great.
Zoomed in - looks like the AP logo is a bit wonky (not straightened) but everything else looks on-point and great.
Last edited: