• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

Which Hand height kit for Selita sw200 to LMPO

richard2

Looking Around
8/8/14
3
0
1
Hi, I hope this is right forum for my Question. I have learned alot from this good forum it very good.

I have a LMPO bouth 2014. The movement stopped working a while ago and then i bought a Sellita sw200 to replace it with. I thouth it should fit in the watchcase and it did. But when i should put the hands back, i noticed that the hands kit was too short for my LMPO so i can’t set the hands back. I have found on ebay a hand height kit that do that. (it says for Eta 2824 but what i have read Eta 2824 parts is compatible with Sellita sw200) Know i wonder whitch of these kit shall i order H3 ,H4 or H6 or is there anyone who sells the Sellita SW200 movement or Eta 2824-2 with the right had height for my LMPO on ebay or elsewhere. Is it difficult to exchange the hand height kit? I have searched for a link where it shows how i can do it, but not yet found any. Maybe you know any good one?

Thanks in advance.
 

Maron

Mythical Poster
16/2/15
9,469
806
113
Canada
Your lmpo should have come with an a2836, so i think you need a sellita sw 220 to replace it, or an eta 2836
 

richard2

Looking Around
8/8/14
3
0
1
Your lmpo should have come with an a2836, so i think you need a sellita sw 220 to replace it, or an eta 2836
I look in the specification for the lmpo when i bouhgt the watch and there it is asian ETA 2824. But if it goes with sellita sw 220 or an eta 2836 i will go for that
 

Maron

Mythical Poster
16/2/15
9,469
806
113
Canada
I look in the specification for the lmpo when i bouhgt the watch and there it is asian ETA 2824. But if it goes with sellita sw 220 or an eta 2836 i will go for that

they advertise it with 2824, but it's 2836. You can tell because the date flips over instantly at midnight, a 2824 would slow roll over between 11:45 and 12:00
 

richard2

Looking Around
8/8/14
3
0
1
Ok, I will test SW 220 then. When i compared SW 200 it have H2 hand fitting hight as standard and SW 220 H4 as standard hand fitting hight. Thanks! for answer.