- 7/6/16
- 4,402
- 218
- 63
I have this blue dial TF 15400 and some spare JF screws. I always wanted to swap out the TF screws because I wasn't sure if anyone here already tried this. I finally got around to it this week. I was hoping the swap would make a big difference but somehow it doesn't. The smaller JF screws somehow look bigger after they're swapped out. What do you guys think?
I have this blue dial TF 15400 and some spare JF screws. I always wanted to swap out the TF screws because I wasn't sure if anyone here already tried this. I finally got around to it this week. I was hoping the swap would make a big difference but somehow it doesn't. The smaller JF screws somehow look bigger after they're swapped out. What do you guys think?
![]()
Bezel is rotated one screw too much clockwise or 45 degrees too much clockwise.
Bezel is rotated one screw too much clockwise or 45 degrees too much clockwise.
Your bezel is set at the wrong angle, the brushing pattern should run vertically, from 6 to 12
It is indeed! I was wondering why the brushing looked so off after replacing the screws :nerd: 45 degrees counter-clockwise it is then.
How did you do to polish the cash? It is a show.
Just in from m2m. Prof's double AR crystal amaze me every time and this one doesn't disappoint. My 1st 44mm AP going to take a little time to get use to the increased size but I've wanted this model for a long time
![]()
![]()
![]()
![]()
sent from my Samsung edge plus v6s
Thanks
Just in from m2m. Prof's double AR crystal amaze me every time and this one doesn't disappoint. My 1st 44mm AP going to take a little time to get use to the increased size but I've wanted this model for a long time
![]()
![]()
![]()
![]()
sent from my Samsung edge plus v6s