Hello
Finally I´ve finished production. Crown is almost 1:1, using original sizes provided by hixxy and perfectly reproduced. Can be used with my original crownguard, just need to adjust lever, normally will need a little sand, because crowns are close to case, and this one is separated.
Can be installed in DSN and Jacksontse/Getat cases, as all my projects made before, easy fitting is key, due to this long times, since beginning the project until it ends. As said in Hugo Boss advertising, Innovate don´t imitate
crown is springloaded, and can be retheaded up to 1.6mm, but production will be released with a 1.2mm thread for an easy fit.
Other threads can be suplied as special order.
For your information. This crown has been manufactured following horlogery procedures. No Glue, no solder, just presure fit, as this things must be done, the real deal, no easy way
hope you like it
Finally I´ve finished production. Crown is almost 1:1, using original sizes provided by hixxy and perfectly reproduced. Can be used with my original crownguard, just need to adjust lever, normally will need a little sand, because crowns are close to case, and this one is separated.
Can be installed in DSN and Jacksontse/Getat cases, as all my projects made before, easy fitting is key, due to this long times, since beginning the project until it ends. As said in Hugo Boss advertising, Innovate don´t imitate
crown is springloaded, and can be retheaded up to 1.6mm, but production will be released with a 1.2mm thread for an easy fit.
Other threads can be suplied as special order.
For your information. This crown has been manufactured following horlogery procedures. No Glue, no solder, just presure fit, as this things must be done, the real deal, no easy way
hope you like it