What did you have to modify inside the case to get the movement to fit?
The movement fits inside the case as is, only issue you run into is crown height puts a slight pressure on winding stem, mounting the movement, and getting pushers to line up.
What did you have to modify inside the case to get the movement to fit?
Longwood Oh man this is a cool project. I have reshaped a few Daytona cases, both ARF and noob. I have found it is easier to get nice clean lines on the profile of the lugs with the noob case. I will try and find some pics of both
This one is an ARF
Wow man, that’s beautiful! Thank you for sharing those photos. Knowing what goes into shaping the case I have a special admiration for seeing how good that looks!
have you ever looked into lowering the rehaunt high? It’s 2mm taller on the noob.
The Center pusher tab was shorted to match exposed area of gen, as well as the case has a spacer made to stop threaded stop from going as deep.
ill grab some more photos soon, my 4130 finally got struck by the keyless issue.
sending it off to have keyless repaired and then finish it.
in the mean time, the arf bezel, dial and gen hands all arrived!
also this is using the v2 arf case which is different !