Just want to post an update on my build.
I was able to find a flat acrylic crystal with beveled edges in 33 mm to fit my modified case.....sort of.
Its a snug fit and I was able to get the crystal to fit over the outer lip of the case and while applying light pressure I installed the bezel. A bit of a sketchy fit but so far it is holding tight with no issues....
I prefer the flat crystal over the domed that I had on there.. The domed crystal seemed to magnify the rehult where the flat does not. The flat crystal isn't as tall as the gen...the profile isn't correct but its as close as I can get without pulling the entire watch apart doing more machine work to the case and bezel or sourcing a taller crystal which I will be looking for.
Overall I would consider this project done!! I am quite satisfied with the results...Its a full custom built one off.
Domed crystal
View attachment 102874 View attachment 102875
vs flat beveled crystal
View attachment 102876
View attachment 102877
If you would like to check out the build thread for this watch.:
https://forum.replica-watch.info/threads/rolex-milgauss-1019-the-scientists-watch.401376/