Hi Guys,
I'm on a franken project for my Omega Plongeur Professionnel V2.
I found some gen parts and start to disassemble the watch.
Take appart the bezel was a nightmare and now, i have to swap the "orange button" but i don't know how to do it.
I think the pin is maintained by the ring which is assembled "forced" (i don't know if it's the right word, sorry), not screwed.
I see a little hole in the side of the ring but i don't know if i must use it.
Does anyone already disassemble a Ploppy V2 ?
Thanks fo your help.
I'm on a franken project for my Omega Plongeur Professionnel V2.
I found some gen parts and start to disassemble the watch.
Take appart the bezel was a nightmare and now, i have to swap the "orange button" but i don't know how to do it.
I think the pin is maintained by the ring which is assembled "forced" (i don't know if it's the right word, sorry), not screwed.
I see a little hole in the side of the ring but i don't know if i must use it.
Does anyone already disassemble a Ploppy V2 ?
Thanks fo your help.