Fully Modded ROO SS Diver Project D.

[chris3007]

And after that we wait for a good C&W white ceramic case [emoji6]


Sent from my iPad Air 2

 

[tinitonsi]

Oh yessss... I believe in the C&W Workshop

 

[umaxim]

hoT! maybe only hair need re-coloring, so roots don't show up lol... just kidding - (but we pay attention to detail on this forum)

Need to come in that place
You're a lucky mane, you know ?

 

[slaughterer62]

This Tini build, and the Franken Diver by ciceroyeah are really the references for Diver modification. I look up to them and admire them constantly.

 

[tinitonsi]

This Tini build, and the Franken Diver by ciceroyeah are really the references for Diver modification. I look up to them and admire them constantly.

Thx J

 

[umblackbear359]

Congrats Tini: a well-considered and planned mash up. Sometimes you run into minor alignment problems when using Noob tachy with JF dial, etc. The JFac glassware is clearly always superior to the Noob in clarity (except for the 3.5 cyclops, which was probably the best one ;-)). Swiss always has better "crown feel" and runs better. I only have Swiss 2824s on my 2 Divers. For some reason, though, I never upgraded my Diver past the 3.5 with mods.

I have a 3.5 and a v6. How do you think I should combine them? Go v6 with the noob dw?

 

[tinitonsi]

I have a 3.5 and a v6. How do you think I should combine them? Go v6 with the noob dw?

Just take the bezel, Xtal, bezel's screws, midcase gasket, the 2 crowns, plots's screws from your V6 and put them on your V3.5

 

[MR.JAMES_BOND.007]

Beautiful!

It just back with a low beat movt, haha
Thx to my buddy Chris3007 for the insane work he did

https://vimeo.com/136544825

 

[randy21]

Sorry I'm a noob here, and correct me if I'm wrong, but after researching, the jf v7 hour hands lines are still thicker than the noob v5.1 diver right? Why you choose to use the v7?


Sent from my iPhone using Tapatalk