Hi,
As the start of the collection of parts for a 55XX Sub build (looking like a Ruby case for a early 1970's metres first ) I received a ETA 2824-2 Elabore in the post today.
In the movement case was a toothed wheel wedged sideway between the movement body and the case. After some googling I gather that this is the hour wheel for the watch hand The same googling suggests that a small thin brass dial washer would be needed for the installation of the hour wheel.
Eventually there would be the need for dial ring, clamps and screw.
Question is, should I source a dial washer for the hour wheel or would that come with a to be purchased dial, and would the clamps and screws come with a purchased ring that supports the 2824 movement in the case.
Thanks in advance for answers and any suggestions as to where to get the parts.
Cheers
As the start of the collection of parts for a 55XX Sub build (looking like a Ruby case for a early 1970's metres first ) I received a ETA 2824-2 Elabore in the post today.
In the movement case was a toothed wheel wedged sideway between the movement body and the case. After some googling I gather that this is the hour wheel for the watch hand The same googling suggests that a small thin brass dial washer would be needed for the installation of the hour wheel.
Eventually there would be the need for dial ring, clamps and screw.
Question is, should I source a dial washer for the hour wheel or would that come with a to be purchased dial, and would the clamps and screws come with a purchased ring that supports the 2824 movement in the case.
Thanks in advance for answers and any suggestions as to where to get the parts.
Cheers