Thanks for all the comments guys. I appreciate it.
It was a trick question - it's my watch with the following specs.
- Gen APH dial
- Gen bezel
- Gen Crystal
- Gen gasket
- ARF v1 base (before the noob4130 came out) with working big chrono hand
- swapped the 3 subdial hand with the 6 hand (stock ARF the 6 Sub dial centre pinion is different to the faux 3 and 9 subdial centre pinion - big tell IMO)
- case reshaped incl. lugs and cgs to gen spec by backwoods Jon
- pusher lengths shaved down by backwods Jon (ARF too long and at a slight angle to gen but there is nothing we can do about the angle...)
If only the noob 4130 movement fit in this case it would be a beast...
Guess I'm sending this back to my watchsmith to get the dial recentred...
Shows how good rep hands are also.
Thanks again.
It was a trick question - it's my watch with the following specs.
- Gen APH dial
- Gen bezel
- Gen Crystal
- Gen gasket
- ARF v1 base (before the noob4130 came out) with working big chrono hand
- swapped the 3 subdial hand with the 6 hand (stock ARF the 6 Sub dial centre pinion is different to the faux 3 and 9 subdial centre pinion - big tell IMO)
- case reshaped incl. lugs and cgs to gen spec by backwoods Jon
- pusher lengths shaved down by backwods Jon (ARF too long and at a slight angle to gen but there is nothing we can do about the angle...)
If only the noob 4130 movement fit in this case it would be a beast...
Guess I'm sending this back to my watchsmith to get the dial recentred...
Shows how good rep hands are also.
Thanks again.