• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

BP Sub Mid Case

Atticus

Active Member
6/2/11
321
1
18
Does anyone know where I can source one? The tube snapped inside the crown. Tried TT but he says the factory does not carry them. Any help would be appreciated, Thanks
 

Bonesey

Mythical Poster
Advisor
15/1/11
8,926
68
0
Just replace the tube and crown with a TC set. Or a TC tube and gen crown.
 

tr573

Renowned Member
17/10/11
796
87
0
It snapped inside the mid case

you can still remove that portion of the tube from the case, you need an ez-out. You don't remove tubes from the outside anyway (unless you feel like destroying them)
 

Bonesey

Mythical Poster
Advisor
15/1/11
8,926
68
0
Lowes #1 screw remover and job done. Hell I've even chocked it up in a vice and drilled them out with a small drill bit before.
 

woof*

Renowned Member
25/12/10
566
2
0
Rat end of a small rat tail file works in a pinch too.
Clark's tube sets for # 703 crown are around 13$
 

Ephry73

I'm Pretty Popular
10/6/11
1,826
1
0
The all of the "accessories" off the mid case and heat up the area below the tube. Use a rat file end and unscrew it. Should come out. Then replace tube as needed.
 

Bonesey

Mythical Poster
Advisor
15/1/11
8,926
68
0
Using a gen spec tube would mean that countersinking the case. A TC tube is flat bottomed so would work better.

Sent from my Nexus 7 using Tapatalk HD
 

R2D4

Admin
Advisor
15/4/07
14,908
56
48
Using a gen spec tube would mean that countersinking the case. A TC tube is flat bottomed so would work better.

Sent from my Nexus 7 using Tapatalk HD

This Times a thousand. \_ _/ Something like that. ;) The gen is angled.
] [