Best PAM with SS Bracelet

[Rufctr2]

Some picts as i received the VSF 320 V2 during the exile.
The gen bracelet fits perfectly the case. I tried a ceramic from a Tuttonero V1 (vsf too), and the strap couldn't pass between the lug.

So the V2 case seams really gen like as there isn't any play or gap.

The fitting is even better than with the Noob 356. Of you look at the picts of the 35§ with gen bracelet, the bracelet is perhaps 0,5mm too high. With the 320 GMT V2 VSF case and bracelet are perfectly aligned.

 

[mysterio]

Some picts as i received the VSF 320 V2 during the exile.
The gen bracelet fits perfectly the case. I tried a ceramic from a Tuttonero V1 (vsf too), and the strap couldn't pass between the lug.

So the V2 case seams really gen like as there isn't any play or gap.

The fitting is even better than with the Noob 356. Of you look at the picts of the 35§ with gen bracelet, the bracelet is perhaps 0,5mm too high. With the 320 GMT V2 VSF case and bracelet are perfectly aligned.

Thanks for the confirmation. Tried the rep bracelet on the PAM312 with the P.9000 clone (balance wheel @7) and the lug pin would go through the lug and the bracelet but would not fit into the other lug hole. The lug pin is slightly at an angle which makes the alignment of the pin impossible.

 

[Rufctr2]

I only filed at hand the pin for the gen bracelet. The angle is really really thin and it passed. But the Tuttonero V1 bracelet cant be put (even for test) on the 320 gmt v2. There must be a small difference in the case angles between the 438 V1 and the 320 V2