Hey guys,
Im in a bit of a bind and need your advice on this.
I ordered a white PF 5711 watch, along with a PPF dial hands set/Keylog DWO. The PPF dial that was sent to me did NOT come with QC pics from my TD - that was mistake number 1 on my part.
Anyways, fast forward to now. I sent the Watch/dial/hands/Keylog to a recommend watch smith on this site and he installed the Dial/hands/DWO and he did a wonderful job - the only problem is the Date window boarder on the PPF dial is insanely misaligned. (not my watch smiths fault, it came from he factory this way). I was unaware of the defect but unfortunately he installed the dial before sending me the QC pics where I noticed the defect.
I contacted my TD and he said he would refund me for the PPF dial, but he can't get a hold of a new one for me now. I also contacted a few other TD's and everyone says it would take them a few months.
So now my options are 1) accpept the with as is, with messed up PPF dial, DWO and PPF hands installed.
or 2) (if its possible) Reinstall the original PF dial, and hope the DWO works and keep the PPF hands installed.
My question is, what do you think the best thing to do in this situation would be? Will the PPF hands clash with PF dial if I reinstalled the original dial? Should I just swap everything back to PF spec? Will my DWO for PPF dial even be compatible with PF dial?
Thanks for the help.
TG
Im in a bit of a bind and need your advice on this.
I ordered a white PF 5711 watch, along with a PPF dial hands set/Keylog DWO. The PPF dial that was sent to me did NOT come with QC pics from my TD - that was mistake number 1 on my part.
Anyways, fast forward to now. I sent the Watch/dial/hands/Keylog to a recommend watch smith on this site and he installed the Dial/hands/DWO and he did a wonderful job - the only problem is the Date window boarder on the PPF dial is insanely misaligned. (not my watch smiths fault, it came from he factory this way). I was unaware of the defect but unfortunately he installed the dial before sending me the QC pics where I noticed the defect.
I contacted my TD and he said he would refund me for the PPF dial, but he can't get a hold of a new one for me now. I also contacted a few other TD's and everyone says it would take them a few months.
So now my options are 1) accpept the with as is, with messed up PPF dial, DWO and PPF hands installed.
or 2) (if its possible) Reinstall the original PF dial, and hope the DWO works and keep the PPF hands installed.
My question is, what do you think the best thing to do in this situation would be? Will the PPF hands clash with PF dial if I reinstalled the original dial? Should I just swap everything back to PF spec? Will my DWO for PPF dial even be compatible with PF dial?
Thanks for the help.
TG