Hi so my guy put together my watch it’s a VR 116610 LV with a gen bezel assembly including gen retaining ring.
Problem is the bezel sits 1-2 mm too high. Like the retaining rings needs to be shorter or pressed more?. I can push it down so it’s flush with the case but it pops back up once in a while. I can’t pull it off so it’s secured on.
Can you help fix this?
Here’s some pics
And if I push it down
Also if you in conus and know how to help I appreciate shooting my a PM so I can send it over.
Thank you all
Sent from my iPhone using Tapatalk
Problem is the bezel sits 1-2 mm too high. Like the retaining rings needs to be shorter or pressed more?. I can push it down so it’s flush with the case but it pops back up once in a while. I can’t pull it off so it’s secured on.
Can you help fix this?
Here’s some pics
And if I push it down
Also if you in conus and know how to help I appreciate shooting my a PM so I can send it over.
Thank you all
Sent from my iPhone using Tapatalk