Tudor Ranger/ blackbay CP height

[mech500]

Hello,

Anyone know the correct hand-stack height for Ranger heritage and Blackbay?

I assume the stock rep has h2 (short hand stack) and not h4 (tall hand stack).

I am looking at my v6f ranger and the hour hand is too close to the dial. Makes the hands look flat and less 3D (basically looks ugly).

Is h2, h3, h4 correct for Tudor ranger?

Thanks,
Mech

 

[PaulyWalnuts]

Nope it's all wrong, send it to me and I'll take great care of it [emoji12]
...but on a more serious note, I'm not sure what the hand stack height is on a Genuine Heritage Ranger but yours looks fine to me.

Sent from my iPhone using Tapatalk

 

[spazthecat]

Not sure what the gen uses but I replaced mine with an H4 height setup and now I think it looks a bit too tall.

https://forum.replica-watch.info/vb/showthread.php/319180-Tudor-Ranger-tune-up!


Sent from my iPhone using Tapatalk

 

[mech500]

Not sure what the gen uses but I replaced mine with an H4 height setup and now I think it looks a bit too tall.

https://forum.replica-watch.info/vb/showthread.php/319180-Tudor-Ranger-tune-up!


Sent from my iPhone using Tapatalk

Ah, thanks. Yeh, I suspected h4 might be too tall for the ranger.

I actually have x2 Rangers. One has very low hand stack and the other looks normal [emoji848]

 

[honneypk]

i am also searching the difference is there any difference in v6f batches as well ? i.e v1 or v2 . i am new sorry if i sound stupid

 

[mech500]

i am also searching the difference is there any difference in v6f batches as well ? i.e v1 or v2 . i am new sorry if i sound stupid

I purchased x2.
Both v6f v2.
In real life one has a slightly shorter CP.

the difference is only micro milimeter and impossible to see in pics.

It's probably just manufacturing and/or assembly tolerance

Great watch nevertheless and a true super rep IMO.

Basically Impossible to get called out.

 

[rocketdogbert]

@mech500 Did you get an answer on this mate?

I just picked up a Heritage Rnager from RWG and the hour hand is very (so low in some lights you can see it's marking the dial).

I'm thinking H3 conversion, or just a tear down and adjust, unless you have any other advice?

Cheers

rdb

 

[mech500]

@mech500 Did you get an answer on this mate?

I just picked up a Heritage Rnager from RWG and the hour hand is very (so low in some lights you can see it's marking the dial).

I'm thinking H3 conversion, or just a tear down and adjust, unless you have any other advice?

Cheers

rdb

Sorry buddy, just saw this now.

Unfortunately, I did not get a definitive answer to the CP height question.

I have decided to live with the stock CP on both my watches.

H3 could look interesting - but i have grown used to looking at my stock h2 and it looks right.

Definitely have yours fixed and wear it well!

Here are mine on gen bund leather and gen ammo:

Sent from my iPhone using Tapatalk

 

[rocketdogbert]

looking good mate, I'll try and raise the hands a tenth of a mill myself, see how I get on, thanks