Tudor Pelagos case opener?

[Arko]

Anyone knows what size die the tudor pelagos titanium case backs are?

 

[ikiestik]

Duct tape.

 

[zsolie]

Small sticky ball.

 

[carlton]

This!! Can easily get from Ebay, cheap and useful enough.

 

[Arko]

i have one of those sticky ball already, I just don't trust it for closing the case back enough to be 100% watertight

 

[ajs914]

It is the standard die for a 40mm oyster case. 29.50mm

 

[Arko]

thanks!

too bad i already ordered the 29.5 and 36.5 dies

 

[ajs914]

I use the ball for as much as the process as possible to minimize the risk of scratching the case back and then use the die for the last little bit.

I have to say that I found the Pelogos ti threads very hard to screw down. By hard, I mean that the ti surfaces don't want to slide against each other very smoothly. It feels like they are galling. I assume it has to do with ti versus stainless.

 

[Arko]

so 29.5mm was the correct dye. I ended up buying the bergeon one, the knockoff version was too even scratch the teeth of the case back, let alone turn it.

 

[johnlogan]

Its bigger than the rolex size! Any know where I can obtain the correct size?

 

[JJCW]

I resume the topic to understand if anyone can confirm the case opener dye size for such model.
Is it really the 29.5 mm?
I'm asking since case is 42 mm but back open diameter seems to be around 33 mm and I pointed out that there is a dye with 33.5 mm.
Thanks in advance for any possible suggestion



Inviato dal mio LLD-L31 utilizzando Tapatalk

 

[johnlogan]

The older 2 liners uses the same opener as a Rolex. The newer Pelagos needs a much larger case opener. I have not seen this vase opener sold anywhere. You will most likely need a 3 x point :
https://www.ebay.com/itm/Adjustable...4749825bc4b0712ad78c|ampid:PL_CLK|clp:2334524

 

[JJCW]

Thanks! Actually I found bigger sizes from 30.5 to 36.5 mm on Aliexpress. They are described to fit with bigger Tudor. My issue is to understand which should be the corret on. Measuring the back open, the diameter between teeth seems 33.3 mm, thus I suppose a dye 33.5 mm should be suitable. But I'm not an expert and I'm trying to find some further information.

Inviato dal mio LLD-L31 utilizzando Tapatalk

 

[JJCW]

Just to complete the topic, the right size is 33.5

Inviato dal mio LLD-L31 utilizzando Tapatalk

 

[miami_YG]

Just to complete the topic, the right size is 33.5

Inviato dal mio LLD-L31 utilizzando Tapatalk

Hate to dig this up, but I'm search for correct Black Bay 58 size. Is the 33.5mm for Pelagos the same?