Hi guys can anyone give me some step by step instructions with pics on how to remove and reinstall the Xf factory Tudor pelagos bezel ?
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
Tudor pelagos bezel removal
- Thread starter breitling87
- Start date
capice
I'm Pretty Popular
- 12/12/07
- 2,713
- 558
- 113
I’ve searched and read that the rep pelagos bezel goes on different to gen. I’ve found some threads before with pics on rwi but can’t find any now. Have taken the bezel off but can’t get it back on!
Could you post some pics? Meister Hora removed the bezel on one of mine (V3) and strechted the springs to tighten the bezel.
Worked fine, but maybe there are different bezel assemblies? Is it a miyota v3/v4 or an older v1/v2 with a2824?
Last edited:
has anyone figured out how to remove/replace the bezels on these yet? found this watch in my draw still with the bezel off how many years later..
Replisimio
I'm Pretty Popular
No it’s the same as gen. I have a gen bezel on my XF and it fits just the same as a Rolex bezel with a hytrel ring buddy. Mine is the eta V5 version but I’m sure the others are the same. I’ll hav3 a look and see if I took any pics when it was in bits.
Sent from my iPad using Tapatalk
Ah that would be great. I think my issue is I’ve lost the spacer ring if there is one. All I’ve got is the white gasket sitting in the ring
Replisimio
I'm Pretty Popular
That should be all you need. All I could find was this showing the ring. The bezel fits direct to the case on mine. Maybe you need to show some pics for me to see what might be wrong. The white ring does sometimes need to be the correct way up to snap in correctly though.
Sent from my iPad using Tapatalk
