Timegraph results on Pam088 GMT ok???

[allez]

Hey folks, please help!
Got Timegraph QC pic from a TD and for me the results are not very clear.
I tried to interpret them with searching in the forum... maybe a established guy of you here could help to make clarity on this issue (mainly amp. & beat er.)
Is the movement / datas still ok?
Maybe the power reserve was not wound enough so it could be better when reserve is more charged or the movement runs a few weeks (??)

thanks a lot in advance!!

the datas see below on the pic

 

[Wiz]

It's fine mate, no worries.

 

[trailboss99]

Amplitude is a little low which is causing one end of the pallet fork to mis-strike on the wheel but nothing to worry about on a rep. It's quite normal for rep movements and yes, it could very well be that they only did wind it a few turns. I'd expect to see improvement after a few weeks use. I wouldn't be refusing it on the basis of that pic.

 

[allez]

thanks for quick reply. I think I will ask the TD to wind it a little more and check it twice.
Should be my "daily rocker" so I´d like to keep it for a longer time... And Buying a watch with obvious problem isn´t my purpose as you can imagine and I don´t know a watch smith unfortunately

btw hope you understand my "German" English

 

[trailboss99]

No, there is no problem, it will be fine. It is within the limits of what you expect from a 300 dollar watch with a 100 dollar movement. As I said, quite normal and no reason to refuse. You won't get any better results from an out of the box A7750.

 

[allez]

No, there is no problem, it will be fine. It is within the limits of what you expect from a 300 dollar watch with a 100 dollar movement. As I said, quite normal and no reason to refuse. You won't get any better results from an out of the box A7750.

THANKS mate
Sead confirmed that he didn´t wind it a lot times before he tested it...so everything ok he says