Ti PAM 56/55 franken and T's T48 crown... pics

[projectologist]

T's t48 crown arrived today and fit perfectly on the gen 56 case set with std. (non-destro) ti gen cg. May have to shave a hair off the lever for the final fit. Haven't decided which rep brown-dial to use to finish the project... hard to judge the brown in most pics. Any recs?

Robert in SoCal

 

[LegendofSpeed]

i'd go with a cartel dial... the first inclination is for people to go with DSN's, but it is slightly more purple than it should be..

of course, since it's a newer type CG, maybe you should go for a 176/177? sell the caseback and use the cash for parts...

 

[projectologist]

i'd go with a cartel dial... the first inclination is for people to go with DSN's, but it is slightly more purple than it should be..

of course, since it's a newer type CG, maybe you should go for a 176/177? sell the caseback and use the cash for parts...

I thought about the 177/76 route but the cg is C, D with the ss pin and lever... G series and beyond went all ti cg parts.

Robert in SoCal

 

[LegendofSpeed]

i remembered when i saw it that it had the high arch along the top... must be mis-remembering...

 

[projectologist]

i remembered when i saw it that it had the high arch along the top... must be mis-remembering...

hmmm... I'm looking @ it now from the side and it's pre-H thinner above the lever and thicker below. I do see a very slight doming on the top surface area. I'll be back up for a visit in another week or 2 and REALLY want to see the completed 63 you posted!

Robert in SoCal