seamster 007 bezel adjustment

[cmaster]

The bezel on my rep 50th anniversary seamaster isn't right.

It doesnt line up with the notches on the outside of the bezel (the cut out parts).

Are the bezels/bezel inserts easy to get out?

All it needs is the insert taking out, advancing along about 5 degrees, then replacing to line up.

Can anybody help guide me?

 

[d4m.test]

I've seen this happen on a gen as well as a few reps. Short of taking the watch apart and prying it off to reapply, the only thing I can think of is using a hair dryer to warm up the glue and then turning it.

Not sure if it would work though. Just an idea that I've never tried.

Sent from my Galaxy Nexus using Tapatalk 2

 

[cmaster]

I've seen this happen on a gen as well as a few reps. Short of taking the watch apart and prying it off to reapply, the only thing I can think of is using a hair dryer to warm up the glue and then turning it.

Not sure if it would work though. Just an idea that I've never tried.

Sent from my Galaxy Nexus using Tapatalk 2

Thats an interesting idea.

I bought from Ryan - he's suggested i send it back to him - along with a CrPO whose crown pin has come out.
The cost of the postage and time from europe back to him puts me off that idea a bit though