Rolex Daytona 6239 Pusher - Help?

[Tysodrum]

Hello. Looks like my pusher spun itself out and fell off. It's gone. Does anyone have one or know of the best place to get one? I need the pusher and the little pusher base that screws into the case. (Sorry for the wrong terminology.)

Thanks!

 

[alligoat]

You don't say which case you have- cartel, DW, or what?
You can get a pusher from Ofrei or Jules Borel but the threads may not match what you have.
I believe the threads on the Ofrei pushers are 2.5mm x .25.
DW pushers are 2.5mm x .20. Don't know about the cartel Daytonas or Phong either.
Rolex tap is 2.5mm x .25 so you could run the tap thru the hole and go from there

 

[bc1221]

you might wanna open the back and make sure there isnt a little e or c clamp that got loose.

those pushers dont look like screw ins.
some of them are held in to the case with a tiny e clamp on the inside of the case.
if its loose in there, it can get caught up in the gears and trash your movement.

i had this happen but caught it immediately after it happened.

open the back and push in the other pusher. see how its held in. if theres a little C shaped clamp on it, then you have one in your movement somewhere.
shake and hope to god it falls out.

edit:

heres what it would look like

that little c shaped thing.

good luck

 

[Tysodrum]

Thanks for the help guys. Turns out they are screw in. No luck on finding one. I'll try to source one... Thanks.