Replacing a pearl on a PO 42mm

[tangle]

I have a new pearl for my PO 42mm, I bought a new bezel but the sizes are slightly different, however it looks like the pearl and pearl holder will swap over. I have removed the pearls and the new one should just glue in.

What glue should I use ?

Is it better to remove the whole bezel or can it be glued in-situ?

thanks

Peter

 

[amptor]

I'd use clear epoxy if I was doing any gluing of a pearl. By the way, nice watch.

 

[Francisco]

here you have a step-by-step tutorial

http://forum.replica-watch.info/vb/showthread.php/reluming-bezel-insert-pearl-with-45774

 

[cptkirk]

Can you show a pic of the pearl and may I ask where you got this from?
I need to do the same to my 45mm PO.

Good luck...

 

[Q5?]

Nice 4th gen PO!

 

[R2D4]

Or just pop the insert out and make one to install beneath the insert.

http://forum.replica-watch.info/vb/showthread.php/r2s-making-po-pearl-49425?t=49425&highlight=R2's