Replacement dial for 380? Preferably in Conus?

[fourinarow]

Hi all.

Recently acquired a 380 from LupTak (thanks again man!) and am loving it, however, the R_AI fault is starting to bug me a little.

Does anyone know of any strong dial sources for the 380, preferably in North America? Am willing to buy from overseas, but like to keep these sort of things domestic as Im pretty impatient!

I've searched the forum but not luck narrowing down the results to just this question.

Thanks!

 

[mysterio]

You're looking to replace the PAM380 dial with one with the correct spacing? There aren't any, unless you are looking to buy a gen dial of which I have not seen any for sale anywhere.

 

[RWI27]

http://forum.replica-watch.info/vb/showthread.php/pam380-and-cali-138683

 

[ALE7575]

http://forum.replica-watch.info/vb/showthread.php/pam380-and-cali-138683

This 380 dial is a rep and has the same R_AI issue

ALE

 

[fourinarow]

You're looking to replace the PAM380 dial with one with the correct spacing? There aren't any, unless you are looking to buy a gen dial of which I have not seen any for sale anywhere.

Yep, im looking to replace the rep with a better rep. Would have thought someone, somewhere has figured out how to fix the problem and make a new dial, but might be wrong then.

This 380 dial is a rep and has the same R_AI issue

ALE

Thanks, thought as much!

 

[mysterio]

Yep, im looking to replace the rep with a better rep. Would have thought someone, somewhere has figured out how to fix the problem and make a new dial, but might be wrong then.

If someone did make a better dial, you would be sure to read about it. It's one of the last tells on the PAM380, although minor and would require a good look to be able to see it. Here's hoping it is fixed eventually, sooner than later would be preferred of course.