Recommendation for UK based watchmaker to service modded Noob PAM 111

[Phwtan]

Hi all,

I’ve had a Noob v3 that was modded and serviced by Dochere2 about 6 years ago that has been running great until recently.

Recently, if I’m wearing it, the balance will occasionally stop moving. If I bump the watch, it will start moving again and is keeping good time.

if i wind up the watch and not wear it, then it seems to tick fine and keeps good time.

suspecting that it is due for a service. Does anyone have any idea what the issue is?

So I’m looking for a reputable UK based watchmaker that has experience with the 6497 movement. please let me know if y’all recommend any!

thanks

 

[Str1xt]

Ado123 is your man

 

[Carbonara]

Ado123 is your man

+1

 

[superspark69]

Ado123 is your man

ado213

 

[Phwtan]

Seems like it’s unanimous!
thanks for the tip.

ado has worked on my TC v7X several years ago and did a fantastic job. Didn’t realised he was well versed in panerai too

 

[superspark69]

Seems like it’s unanimous!
thanks for the tip.

ado has worked on my TC v7X several years ago and did a fantastic job. Didn’t realised he was well versed in panerai too

the 6497 is one of the easiest movements to work on

 

[Alhig72]

You can buy a brand new A6497 with swan neck regulator (without the panerai engraving) on ebay for about £25-35 and just swap the balance assembly over, super easy 20 minute job, if the problem is something else you have a new movement, either use for parts or put the panerai engraved bridges on the new movement

Look at this on eBay
https://www.ebay.co.uk/itm/392614407806

Sent from my LYA-L09 using Tapatalk