Quick question about misalignment - QC.

[Visio]

Hi,
It’s just me, or it should be different.
I noticed the misalignment. Between slide rule on 2nd photo is no space at all, but on 3rd photo there is a gap. Also deviation of 12s/d it's not too much?

 

[CJS57]

Perspective causes the difference. Straight on picture is truest.

 

[Visio]

On first photo, the straight one looks like the dial goes under the slide rule at 11, and there is gap at 7.

 

[KJ2020]

It looks like the dial isn't perfectly centered in the case opening. This is usually adjustable to a slight degree by loosening the movement clamps, nudging the dial and movement holder in the needed direction and re-tightening the clamps. Sometimes the length of the stem can prevent the movement from being properly centered though.

The S/D is a tad high big not enough to reject the piece.

 

[Visio]

It looks like the dial isn't perfectly centered in the case opening. This is usually adjustable to a slight degree by loosening the movement clamps, nudging the dial and movement holder in the needed direction and re-tightening the clamps. Sometimes the length of the stem can prevent the movement from being properly centered though.

The S/D is a tad high big not enough to reject the piece.

Thanks for info/ suggestions. QC Accepted. After receiving the watch i'll give it to my watch wizard to try to align it correctly.