QC pictures of pam 111

[li55ven]

Hello,

I received the QC pictures of a pam 111N V3 from noobfactory.

Can anybody confirm that it is from noobfactory?

It seems that the watch does not have pre-v hands.I can also see a white dot between 11 and 12

what do you think?

Thanks

 

[Cynikal.Mindset]

I can tell you its a noob and the crown guard is about to fall off...could be dust on the crystal or dial, hard to say

 

[li55ven]

The crown guard about to fall off??

so its not good. i should reject?

 

[karesz501]

You should screw the screws in, that's what it means. Pics are not good quality, but it seems to be pre-v to me. Did you get these pictures or you re-sized them already?

A high-res picture of the front and back would be helpful to judge, the OP lettering looks messed on the bridge.

 

[Rogerthat]

At the very least ask the dealer to tighten the 2 crown guard screws and resend pics

As mentioned pics are low res so tough to tell about much else

 

[li55ven]

"op lettering look mess up on bridge"

i dont understand. quite confused

 

[sharrkey]

Not the best of photos for anyone to help you out with your concerns

 

[ALE7575]

I have already said my opinion about this matter in other thread.
Firstly:
-The wtach is a Noob
-The hands are Pre-V
-The dot is almost microscopic and most likely dust
- Almost all CG of PAM replicas are loosen and many people even lose the svrews and the CGs. You need just tighten them, as all people do in this replica world-
-Concerning other flaws it is impossible to see more with such a low resolution pics.
My friend you cannot send me more than twelve PMs (with their corresponding replies), post QC pics in the V3 thread, now start a not allowed thread with QC pics.

You must stop this way and try to enjoy your replica or just rejecting it and save money for a gen. You will get insane with this matter and you will get insane all people too.

I should close this thread by the QC pics, because RWI Staff has decided not allow QC pics without concrete flaws.
But I understand your troubles and confusion and I will leave things like that, but please be calm and patient.

ALE

 

[watchman12345]

You need a close up pic of the Officine Panerai writing on the movement. You also need to relax!

 

[li55ven]

Here is another QC pic
Is everything fine?

 

[JellyJoe]

Ask for a better pic of the caseback, if you want to make sure the Officine Panerai on the bridge isn't smudged up.
Also ask him to tighten up the screws, just to make sure the threads arent damaged.
my 2 cents

 

[li55ven]

I got other pics!

The only thing that i am not so sure is whether it is the camera flash or the brightness of the room which makes the effect of the black dial fading on the inner loop. What do you think??

Thanks

 

[JellyJoe]

the bridge is perfect. if case and CGs screws are fine go for it

 

[Sora]

I got other pics!

The only thing that i am not so sure is whether it is the camera flash or the brightness of the room which makes the effect of the black dial fading on the inner loop. What do you think??

Thanks

the op engraving looks different from the green background and the white background, becareful of switcharoo

 

[Rwolf]

the op engraving looks different from the green background and the white background, becareful of switcharoo

Serial number is the same. Imho this watch is ok...