Perfection

[asad]

Hi, Guys

For all of you who saw my posts of all the Gens i own. With a daily 1-2 P.M's from fellow members, who ask me to post pics of the Rep I finally settled for.

After spending alot of time on Rep forums.

Here i unveil to you the most perfect Rep to my eyes, when compared to the Gen i had Owned.
(All i can say is, I will probably not buy a Gen anytime soon).

I credit this Beautiful creation to Flav
(The Master of Perfection)

It is a Fully Modded 183G

MODS:
-Custom dial and hands mix lume done next to genuine for comparison to perfect match.
-Dial lower plate polished before lume application to give the silvery look to the dial lume.
-Exact sapphire AR as genuine.
-Tall cannon pin, flattened and polished.
-Swiss ETA Swan Neck G-Series High Rate best model.
-Polished crown tube.
-Lubed and sealed.

"(Caution Please dont start Drooling, These Pictures were not taken by a Proffessional)"

(The Intro Shot)

(The Lume Shot)

(The Wrist Shots, of how i wear this watch during the Week, I know these belong in the Wrist Check section)

(The Average Casual Day Shot Sat/Sun)

(For the Formal get together Friday)

(Work, Work, Work. Mon-Thur)

Thanks
Asad

Hope you enjoyed the Post

 

[coltrim]

very nice - but if you're going to wear that every day you are goimg to have problems with the threads on the crown- unless there have been developments i'm unaware of.

 

[NickNak]

I like, I want......where do I get! Do you have any shots of the back please?

 

[hooligan]

very nice - but if you're going to wear that every day you are goimg to have problems with the threads on the crown- unless there have been developments i'm unaware of.

If you use a little care when you're screwing the crown back in, you should be fine. I had a cheap rep PAM210 for over a year and never had any problems with it.

 

[old skool]

It looks great. Do the rad cases still have issues with the lug bar screws falling out or stripping?

 

[hooligan]

It looks great. Do the rad cases still have issues with the lug bar screws falling out or stripping?

As far as I know, yes. I stripped one of the screws in my DSN 47mm Rad after a single strap change. :| That's why I ordered 4 extra screws and wire lugs when I ordered the watch. :wink:

 

[asad]

Thanks guys i have not had any issues with the screws thread neither the crown. Flav polished the crown tube it does not give any problems.

 

[babola]

As a whole package cool watch, although the satement "-Swiss ETA Swan Neck G-Series High Rate best model" is slightly incorrect, as there's no such mov't made yet (Swiss 6497 High beat rate), bar genuine.

Show us the caseback photo when you get around it, we'll be able to tell you more about the mov't itself. :wink:

cheers,
babola

 

[coltrim]

do gens have the same crown problems?
i've been careful but i've stripped the threads on a dsn and a eddie 183.
it's a real shame because it's the prettiest watch on the planet

 

[hooligan]

do gens have the same crown problems?...

So far, so good on my PAM210. Though, I've only had it for a few months. I wear it alot, though. :wink: