• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

{*PCTeam*}The Last Steps to the Gen(Part I)–Swan Neck & Incabloc Mods.–Jan 2013

Milkbread

Known Member
2/9/14
176
5
0
Thank you Ale for sharing the wonderful information in this thread. You must have dedicated a lot of your time to research and compare the differences.
I learnt a lot about the swan neck, regulator and incabloc, thanks to you!
 

bazzed1958

Horology Curious
27/6/15
11
0
0
I'm a precision engineer and work to tolerances of microns,I have just read Ale's thread and his attention to details and patience whilst putting this together far out ways my skill and technical prowess,I congratulate and applaud you for your wizard skill.
 

undercoverz

Active Member
17/9/15
320
0
0
Such wizardry of precision and details! with your help, I can now verify the Y-Incabloc on my movement is a gen one. Thank you!
 

Nitroboy

You're Saying I Can Sell?
19/4/16
25
0
0
A lot things to do after read this. So easy 1 step is buy noob v3 y inca and replace it swan neck with H-factory.
Thank you Ale for this superb thread
 

dtdomination

Active Member
13/1/20
256
37
28
Any advice on where to find a gen regulator screw? I've been looking for an embarrassingly long time... Thanks!