Just collected my 438 from he watchsmith, had it in my hoodie pocket and the bracelet endlink has come off and was thankfully floating around in my pocket. From what I understand, it's not uncommon. What would you use as an adhesive to glue it back on? Superglue? Thinking I might try and pry the other one off and secure that down too.
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
PAM438 bracelet broken
- Thread starter Norrie
- Start date
How did the endlink come off? There is a screw that secures it, which you can purchase off EBay or elsewhere, if that is the issue.
Has two pins which insert into the lower part. The watch was fine when it went into my hoodie pocket and 5 minutes later it was like this. Glad i didn't lose the lose part.
Has two pins which insert into the lower part. The watch was fine when it went into my hoodie pocket and 5 minutes later it was like this. Glad i didn't lose the lose part.
Superglue will do nicely. Just detach the end link from the rest of the bracelet and the watch head before doing it, of course.
- 9/7/12
- 23,791
- 20,979
- 113
I would recommend an epoxy based resin, considering the low contact level between the 2 pieces.
Right. Same as mine. Will keep an eye out for loose end piece.. i imagine that would be quite easy to loose.
Sent from the RWI mobile app
Sent from the RWI mobile app
Yeah I saw it happened to a few others and was worried it would happen to me too. Glad it happened in my pocket and not on my wrist down the beach.
My bracelet just completely fell apart. I'm all set with the carbon reps that this point.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk