PAM005 vs. PAM000

[CP2K]

What's your opinion and why?

 

[avenger007]

I prefer the base dial, personally. I've put my 000 next to a gen and was very pleased at the accuracy for the money. Can't go wrong with either, though.

 

[CP2K]

Did you notice any obvious flaws, avenger007?
Are there any usefuly mods that can be done?

 

[deja123]

I Love my both ;-)

 

[avenger007]

The CG lever is a bit oddly shaped on all the H-Factory Luminors. The CG pin is closer to the case on the rep. Dial printing on the rep is slightly thicker. The 3 on the dial has a shorter top. The CP could use a bit of a flushing and polishing. If you swapped the Noob CG lever into the H CG, you'd be almost perfect on the CG. Personally, I don't think it needs a thing. On the wrist they are near identical.

 

[juancodb]

buy both.. you wont regret it...

 

[Member X]

+1

 

[Dodgy]

Had both now have neither but have a gen 000 if that tells ya anything.

 

[Klocklind123]

I have put the "whole" new noob CG on both my H-factory K005 V2 and 000.

And I think the the crown from the noob is much better than the H-factory so I have swaped to noob crowns on both and it looks very nice