Hi everyone,
I would like to refinish the CG on my PAM390 to achieve a 1:1 look. I understand that there are numerous amount of guides out there, but I haven't found a standard as to which grit I should be using for the finish.
Is anybody familiar with what grit sandpaper I should be using to get the correct finish? I'm looking for advice for the CG and the CG Pin, as well as the techniques used.
Thanks.
I would like to refinish the CG on my PAM390 to achieve a 1:1 look. I understand that there are numerous amount of guides out there, but I haven't found a standard as to which grit I should be using for the finish.
Is anybody familiar with what grit sandpaper I should be using to get the correct finish? I'm looking for advice for the CG and the CG Pin, as well as the techniques used.
Thanks.
