Pam 286J CG "R.E.G." "T.M"

[Mhernandez82]

Hey guys,

I was wanting a bit of help on where to find this CG for my Pam. I have a post in the wanted section but have not had much luck. I figured I would just ask if anyone knew where else I could look. I received a CG that looked correct however it is too big due to the pushers on the chrono. Any suggestions are absolutely appreciated, Help Please!!!

Thanks in advance. Here are some pics of the watch with the improper CG and one of the QC back when I first bought it.

 

[cwazy1]

If it is only slightly too large, you could always file it down.

 

[Hazz37]

Sent this earlier, but broadband went down, I got a CG from this guy
www.jacksontse.com

 

[chromed.]

u'd need the CG specific for the models with the chrono pushers.. its quite a different CG as compared to the regular 1950s CGs..

dont remember jackson having any chrono pams tho.. your best bet would be to PM a dealer..

 

[Mhernandez82]

Hey guys just an update. I just received my CG from jackson. It is the proper size but the screw holes dont quite line up so i had to tinker with it. But the lever is is very very loose. It swings open just by dropping my hand with gravity.

So i just have a few questions.
1. Is there anyone with another CG for sale? My watch is a 1:1 so it would be great to purchase the proper one.

2. Where else can I source one from?

3. Is there a nice fix to tighten the lever?

Thanks
Sent from the far reaches of my mind.

 

[frigpig]

The easiest way to tighten the lever on the Jackson is to shave the "feet" of the CG. It will bring it closer to the case so the lever will contact the crown.

 

[Mhernandez82]

Thanks frig..i will do that.

Sent from the far reaches of my mind.

 

[ALE7575]

The easiest way to tighten the lever on the Jackson is to shave the "feet" of the CG. It will bring it closer to the case so the lever will contact the crown.

Clever and easy solution Frig
PCTeam working !
Thanks

ALE