PAM 104i too tall CP

[cgn1017]

How do I fix the tall CP issue w the new 104i? Any suggestions would be great. I've seen some come out w perfect CP. Thx

 

[karesz501]

I was thinking about the same as well, maybe one of the modders will chime in.
But I think you can "lift" the upper hand a bit to be flush if it does not make the hand scratch the inner of the crystal. I think.... :thinking:

 

[gianton]

Babola at WC wrote in his review that it's an easy fix. Try to contact him.

 

[gianton]

Babola's reply to me:

By first removing then re-setting the minute hand so it's flush with the CP.

 

[cgn1017]

So it will sit tight on the CP as well too?? I was thinking the hands were pressed in too hard...

 

[cgn1017]

So I tried resetting the hand and it is a little better but when it was completely flush the hand was too loose. I had to push it down a little further to make it stick ;( I just need a new CP...

 

[PolonusTM]

Hmm.. it seems CP cap is an insert into the tube the minute hand is being pressed on. Since lifting the minute hand makes it loose a bit - the only mod solution seems to be:
- removing the CP cap
- cut down the tube to be flush with minute hand
- reinsert CP cap

Am I right?