• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

PAM 022 Destro

Belkin12

Active Member
Supporting Vendor
26/10/12
329
1,171
93
Ukraine
Gentlemen,

this is a pretty rare PAM022 project built for Punk_Boy rwi member. Wear it in a good health, Sir.
Briefly about the build:

The old stock bettarini case significantly reshaped and re-polished. Custom made crown tube with an o-ring installed. Bezel edges smoothed and re-polished. Heavily modified and reworked CG to correspond destro CG look, slimmed and flat as it should be. Custom made flush pin. The lever has a rubber bushing to let it operate smoothly.
The rest of the specs are:

- Custom made solid CB with the 6522 case reference engravings and perlage finish inside.
- T44 deep dish crown, modded.
- 2,7mm thick single-dome crystal.
- Matte black L SWISS L sausage dial (blackened brass) with whitish lume filled indices.
- Custom made 0.3mm backplate is blackened, aged and stamped with model number. Soldered dial feet are for 6497 movement.
- Pre-A hands. Snow white lume.
- a6497 completely serviced (washed, oiled, re-assembled, regulated). OP engravings on the bridges. The Train bridge wheels are radial brushed. The wheels and ratchet screws are re-polished and heat blued.
- H3 CP/HW set. Flat polished CP
- Movement holders made to firmly secure the movement inside the case.
- Titanium lug tubes.
- Custom made tobacco brown vintage leather 24mm 130 x 80mm strap with tobacco thread stitching.
- Blasted engraved 24mm pre-v buckle.

Please note that this is not a regular factory watch but a custom handmade build with certain deviations from gen and its own peculiarities. Though all the parts and services were done professionally it may still have certain imperfections or specific features.


 
Last edited: