Opinion on QC of PAM292 & PAM299

[Stealthy]

Hi guys, I just received my qc pics from TD here and I need opinions from fellow pam expert here

PAM292
http://db.tt/TByeKcXJ
Does the engraving in the back case too shallow?

PAM299
http://db.tt/N1ahRF9D
Does the CG lever looked misaligned when closed?

Both are supposed to be the best noob version

Thanks in advance

 

[Hazz37]

both look fine to me

 

[Blitzgheist]

292 Caseback. The engraving in the highlighted areas (top and bottom) look shallower than the lettering in shadow (left and right). This is just the effect of the lighting, I doubt there is an issue here.

299 Lever. Can't see any misalignment issue here.

Don't forget that these are reps, your level of expectation should reflect that.

 

[John71]

Which TD as I may ask?

 

[Stealthy]

Hi friends, thanks for the comments.

I set my expectations with the other replica photos that I've found here, not by comparing to the gen of course.

I ordered from Ryan - intime, very good response from him.

By the way, the centre pin in 292, should it be silver or black colored? I saw in Toro's comparison between the noob and h factory 292j, it was black colored. But many friends here posted their 292 and it's silver

 

[John71]

Could be the lighting that makes it look silver, I guess it's black

 

[Kleen]

Looks good!

 

[ALE7575]

It is enough

Time to close this thread

QC pics not allowed without serious issues

ALE