oiling 4130 rotor

[CsViking]

hello guys i have a clean factory daytona with sa4130. rotor does sound is it good idea if i put verry little amound of 9010? or let like it is?

 

[RX7GP]

Good question. I was also curious about that. 4-5 drops of 9010 to rotor bearings can be healthy. You can also grease the gaskets while you are at it.

 

[CsViking]

The other thing is if it’s good we need to clean first the rotor of a new watch? Becouse we don’t know what oil clean factory used there so we need to do it from zero? Becouse we may mix oils ? But the basic question is .Is it bad to put 9010 there ?

 

[ffnc1020]

I think HP1300 might be better, I put 3 drops on 3 of the balls and it worked really well.

 

[CsViking]

i read that HP1300 is thicker oil and the problem is it will cause problems after time to the performance. also the 9010 its too thin that you need really small amount becouse if you put a little more the oil will move under the ballbearings and lead problems to other parts... but i dont know whats the right here.

 

[Oascom]

HP1300 should be fine

 

[CsViking]

HP1300 should be fine

thanks for the answear bro can you tell me please becouse im new in that job what are those oils that they mean? (epilame-oil1-oil2-grease0-grease1-grease2) oil1 is 9010 oil2 is hp1300 right? and the others? im on to buy oils and i have 9010 hp1300 and 9412

 

[Giammy]

HP1300 should be fine

But on and between the bearing balls of the central cushion of the rotor, are better some drops of oil or a bit of grease to silence rotor?

 

[Giammy]

I think HP1300 might be better, I put 3 drops on 3 of the balls and it worked really well.

Yeah that’s right, then moving the rotor, the oil swap uniformly to every balls