Need help getting the movement out of my AP JPM JF

[R3w1nd]

Hi guys, one of my chrono pushers has come a bit lose and I need some help with getting the movement out so I can tighten it up.

Originally I thought I'd just unscrew the case back and release the movement from the case bit it looks a bit more complicated case here.
There is a decorative plate on this movements which looks like it needs taking out first before I can remove the crown.

To do this I'll need to take the rotor out firs but can't figure out a way to do it.

I thought it would be fairly straight forward job by unscrewing what appeared to be the 3 small rotor screws but it looks like they are just fake screws and were only glued to the rotor.

So how do I rotor then? If Anyone with experience can chime in I'd much appreciate it.

Below are pictures of the rotor with the fake screw removed.

 

[d4m.test]

Whole center piece is probably the screw, use some tweezers you don’t like in two of the holes, hold the rotor in place and unscrew it.

 

[d4m.test]

It is possible this is the case but I don't really want to force it unles I'm certain it is the way to go.
Maybe someone who has had experience with it can chime in and confirm?

 

[ado213]

Flip the disk out which had the three fake screws in, it is also glued in, it's false. Once out you will see the rotor screw underneath it.

 

[d4m.test]

Oh, cheers @ado213 . I thought about doing this but didn't want to force until someone confirmed.
Much appreciated!