My mini 3646 build

[ocin mreg]

Hello everyone,
I would like to present my construction to you, a mini 3646.
So, a 45mm case from Ali, a dial and hand from Helenarou, a Chinese movement 6497.
I soldered the lugs and the open case back, the hole for the lugs scew , the tube also.
Replaced the glass by a plexy and of course the whole thing.
The sandwish dial has been modified with resin to resemble it.
I find it nice but it's still a bit big for my arm.

 

[black_shark]

Great job!
You could cut the lugs bars a little to help you change the strap when you feel like it.
Enjoy it in good health!

 

[Toofsy]

Nice result.
What did you use to fill in the case back? Same as for the lugs?
Do you have the ref for the plexi?

 

[ocin mreg]

Nice result.
What did you use to fill in the case back? Same as for the lugs?
Do you have the ref for the plexi?

to solder, you need tin and flux. there is no exact reference for plexy. you have to measure the bezel and take the correct dimensions then it clips because each radiomir kit are different

 

[Toofsy]

to solder, you need tin and flux. there is no exact reference for plexy. you have to measure the bezel and take the correct dimensions then it clips because each radiomir kit are different

Thanks ???? your built is motivating me to use an old plexi riveted dial I found in a drawer

 

[kilowattore]

I like the way you created a solid case back, great soldering job.